Sagem 4450E - Manual (Page 109)

SAGEM 3P@C
3P@C Installation Manual
Page 6-2 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Uncompress success, enter device initialize, Please wait...
Entering 3P@COS ......Done.
Initializing environment ...... Done.
Loading startup config ...... Done.
########################################################
### #
# #
# Welcome to 3P@COS. #
# #
# Press Return to connect and config this system. #
# #
########################################################
####
3P@COS V2.0Release7.4.0 on 3P@C 4450EV2.0.
Login:
Step 3 When pressing <Enter> on the terminal, the system prompts you to
input the login user name and password.
Step 4 The default user name for the login at the first time is “admin” and the
password is “3P@C”. The user logging in with this user name and
password has the administrator rights. The display is shown as
follows:
Login: admin
Password: *******
You will first enter the read-only mode of the system after successfully
logging into the system. The command prompt is “3P@C>“. In this
mode, you can only view the system configuration information, since
common users can only enter the read-only mode. If you have the
administrator rights and hope to configure the equipment, enter the
configuration mode according to Step 4.
Step 5 Enter the configuration mode.
Input the enable command in the read-only mode. Then the system
requests you to input the password for entering the configuration
mode. The default password is “3P@C”, as shown in the following:
3P@C>enable
Password: *******
After you successfully enter the configuration mode, the command
prompt becomes “3P@C(config)#”. In this mode, you can perform all
the configuration operations on 3P@C 4450E. For the detailed
description of the related configuration commands and methods,
please refer to the 3P@C 4450E IP-DSLAM Configuration Manual.
Step 6 Save the configuration information.
To make the equipment configuration still effective after the equipment
is restarted, you need to use the save configuration command to save
the configuration information. For example,
3P@C(config)# save configuration
Press Enter and wait for the system to save the configuration
information.
Step 7 Exit the configuration mode.
In the Configuration Mode, you may use the exit command to exit the
Configuration Mode and go back to the read-only mode. You may also
use the exit command in the read-only mode. However, it only
functions to exit the 3P@COS, similar to the function of the logout and
quit commands.
To exit the 3P@COS, use the logout or quit command, or use the exit
command in the read-only mode.