Sagem 4450E - Manual (Page 111)

SAGEM 3P@C
3P@C Installation Manual
Page 6-4 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
6.3. 6.3. 6.3. 6.3. Command Line System
3P@C 4450E adopts the 3P@COS. 3P@COS is the operating system developed specially for its 3P@C series
of products.
Note
All the commands of the 3P@COS command line are
case insensitive.
6.3.1. 6.3.1. 6.3.1. 6.3.1. Command Mode
There are two command modes for the 3P@C 4450E IP-DSLAM : Read-only mode for ordinary users and
configuration mode for administrators. For descriptions of the two command modes, refer to Table
6-1 .
Table 6-1 Description of the read-only mode and the configuration mode
Command
mode Function Applicable
users Command
prompt
Read-only
mode View most of the system
information and
configuration information of
the switch Ordinary
user 3P@C>
Configuration
mode View and configure all the
information of the switch Administrator 3P@C(config)#
The user that logs in the system with default user name “admin” and password “3P@C” is called an
administrator who can configure and operate the switch in both read-only and configuration modes. After the
administrator inputs the correct login username and password, he will first enter the read-only mode. To enter
the configuration mode, he needs to use the
enable command and input the password for entering the
configuration mode. The administrator has both the rights to configure the switch and the rights to manage the
users, including creating/deleting users, modifying user rights, modifying login password and the password for
entering configuration mode.
6.3.2. 6.3.2. 6.3.2. 6.3.2. Common Commands
For a preliminary understanding of the usage of the 3P@C 4450E commands, the following introduces the
usage method of some common commands, as shown in Table 6-2 and Table 6-3.
Table 6-2 Commands in the read-only mode
Command Function
clear Clears the screen display
enable Enters the configuration mode to perform
configuration and write operations on the switch
exit Exits the current configuration mode and returns
to the previous mode. If executed in the read-only
mode, this command will enable users to exit
from the system.
help Shows how to use the syntax help in the
command line
list Shows the list of current available commands
logout Logs out and disconnects