Sagem 4450E - Manual (Page 98)

SAGEM 3P@C
3P@C Installation Manual
Page 4-37 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
prompt
As sho As shown in Figure 4-48, cable ties cannot be
applied in the bending position shown in (1) on the left,
and the correct application of the cable ties is shown in
(2) on the right.
The cable binding is shown in Figure 4-49 and Figure 4-50:
Figure 4-49 Single binding
Figure 4-50 Double binding
4.8. 4.8. 4.8. 4.8. Connecting the Console Cable
The 3P@C 4450E switch provides RS-232C interface (Console interface) of the RJ-45 type, via which the switch
can be connected to the terminal console PC with a console cable. The console cable is an 8-core cable, with an
RJ45 connector at one end for connecting to the console interface of the switch and DB9 plug at the other end
for connecting to the terminal console. The console cable and the console interface are connected as shown in
Figure 4-51. After the connection, you can configure the switch through command lines at the terminal console
for outband management.
prompt
For the description of the RJ-45 connector, please refer to
Section 4.4.4.