Sinclair KING ASH-09AK - Manual (Page 22)

Operating Procedures / Photos
Press the clasps in by till they loose, then lift up
wards the electric cover.
4. Disassemble the electric cover
5. Disassemble water tray
Electric cover
5. Disassemble the electric box
Screw off the grounding wire of the evaporator,
remove the tube sensor and temp sensor support,
put out the connection lines for the step motor
and the indoor motor. Screw off the screws fixing
the electric box. Remove the electric box.
Grounding wire
Connector
Tube Sensor
Temp Sensor Support
Clasps
Claslp
Water tray
Loosen up the clasp at the front of and the rear of
water tray sub-assy and lift them up, can take out
the water tray sub-assy.
Note: Due to the water tray is connected with the
water drainage pipe, please pay more attention do
not to damage the fin on evaporator.