Sinclair KING ASH-09AK - Manual (Page 28)

Operating Procedures / Photos
4. Disassemble the Light Board and electric cover
6. Disassemble water tray
Electric cover
5. Disassemble the electric box
Lossen the grounding wire of the evaporator, re-
move the tube sensor and temp sensor support,
put out the connection lines for the step motor
and the indoor motor. Screw off the screws fixing
the electric box. Remove the electric box.
Grounding wire
Connector
Tube Sensor
Temp Sensor Support
Clasps
Clasp
Water tray
Light Board
Screw off 1pc screw of light board, then
can take down the light board.
Unloosen the clasps of front and rear sides of water tray,
then lift them up, then can take down the water-tray
sub-assy, and pay more attention do not hurt the fin
on evaporator.