Sharp UX-CD600 - Manual (Page 110)

Caller ID and Call Waiting ID (Requires Subscription to Service)
108
1
Press once and once on
the machine.
2
Press once and 8 times.
3
Press once.
4
Press to select SET.
(To clear a previously set area code,
press and go to Step 7.)
Note: Entering your area code in this step causes it to be automatically removed
from local numbers in the Caller ID list (page 111). This is only required if you
need to eliminate dialing of the area code when dialing a local number from the
list.
FUNCTION
4
Press once.
5
Press (YES) to turn on Caller ID.
(To turn off Caller ID, press .)
6
The display briefly shows your selection and then the next option
setting. Press to exit the option settings.
STOP
Entering your area code
If the area code must not be dialed when you dial a local phone number
(within your calling area code), follow the steps below to enter your area code.
When this is done, the machine will automatically remove the area code from
local numbers in the Caller ID list (see page 111), allowing you to dial local
numbers automatically from the list.
♦
If it is okay to dial the area code when dialing a local phone number, you do
not need to perform this procedure.
Display:
OPTION SETTING
AREA CODE #
AREA CODE # MODE
1=SET, 2=CLEAR
ENTER AREA CODE
ENTER 3 DIGITS
Example:
CALLER-ID (L1) CALLER-ID (LINE1)
1=YES, 2=NO
all.book 108 ページ ２００４年６月２２日 火曜日 午後１２時１分