Sharp UX-CD600 - Manual (Page 26)

Setting Up
24
♦
To clear a mistake, press .
♦
To enter a lower case letter, continue pressing the key for the letter until the
lower case letter appears.
♦
To enter one of the following symbols, press or repeatedly:
. / ! " # $ % & ’ ( ) + + , - : ; < = > ? @ [ ¥ ] ^ _ ' { | } ) (
7
Press to store the name.
8
Press to exit.
♦
In the event that you need to change the name, clear it (press “2” in Step 4
on the previous page and then follow Steps 5, 7, and 8), and then repeat
the name entry procedure to enter the new name.
♦
If you purchase an additional cordless handset and enter it’s name after
registering it in the machine, the name is also transmitted to all other
cordless handsets that you have for the machine. For this reason, make
sure that all cordless handsets are within the talking range of the machine,
their batteries are sufficiently charged, and that none are in use before
entering the name of the new cordless handset. To check whether the
name of the new cordless handset was successfully transmitted to the
other cordless handsets, press on each of the other cordless handsets
followed by or until the number of the new cordless handset
appears in the display. The name will appear next to the number if it was
transmitted successfully. If the name does not appear, repeat the name
entry procedure.
SPEAKER
START/MEMORY
STOP
INTER
COM
Display:
HANDSET1
BILL
The handset number
and name appear in
the standby display of
the cordless handset
OWN NUMBER SET
all.book 24 ページ ２００４年６月２２日 火曜日 午後１２時１分