Sony PCNA-MR10 - Manual (Page 115)

About Connecting to a Server
115
Visual and audio reception is interrupted or distorted
❑ The network may not have enough bandwidth.
Check the following, if applicable to your network environment:
❑ The network cables supports 100 BASE-TX.
❑ The network switch or the router device supports 100 BASE-TX.
❑ The connected server or the network may be experiencing overload.
Using the High Quality setting in the Live Mode of the TV Settings screen
may cause your network or system to overload. Try changing the Live Mode
setting to Standard or Low Bandwidth.
About Connecting to a Server
Cannot connect to a server
*
❑ Verify that the VAIO® computer(s) is turned on.
❑ Verify that the network settings are configured correctly.
❑ Check the following, if applicable to your network environment:
❑ A crossover cable is used for a direct connection between RoomLink™
and a single VAIO computer.
❑ The network switch or the router device is turned on. (See the
information supplied with your network switch or router device, for
details.)
❑ The router device is turned on before turning on the network media
receiver.
❑ The network media receiver, network switch, or router device are
properly connected using the appropriate network cables
† .
❑ If using a router device, RoomLink™ and the VAIO computer have
been configured to obtain the IP address automatically.
❑ Verify that the correct server name appears in the Select a server
screen. (The Select a server screen lists all current and previous servers
connected to RoomLink).
* You may see an error message, “Cannot connect to the server.”
† Use network cables that support 100BASE-TX.