Sony PCNA-MR10 - Manual (Page 117)

About Recording and Playback
117
The server is listed as “Unknown”
When is shown for a server, RoomLink™ does not recognize the computer’s
availability and fails to connect.
Try the following steps:
1 Using the Remote Commander, select Connect from the on-screen
submenu.
2 Press OK.
If these steps do not connect the server, check the following:
❑ If necessary, bring the computer out of Standby or Hibernate mode.
(You can configure your computer to enable the network media receiver
to automatically resume from Standby or Hibernate modes.)
❑ Verify the computer is turned on.
❑ Verify the network cable connections are secure.
❑ If using a network switch device or a router device with a built-in
network switch, verify that the equipment is turned on.
❑ Verify the network status is up.
The “Select a server” screen always appears
You can set RoomLink™ to stop displaying the Select a server screen every time
you access a feature, such as TV, Video, Music or Photo. Preset a default server
for each feature. See “Connecting to a server automatically” on page 58, for
details.
About Recording and Playback
The recording stops after 30 minutes
❑ This RoomLink recording feature is preset to automatically stop 30 minutes
after pressing the REC button. After you start recording, the length of the
recording session can be extended by 30-minute increments (up to a total of
6 hours) each time you press the REC button.
❑ You may not have enough hard drive space on your VAIO® computer.
Delete unnecessary files to free up additional space.