StarTech.com SV1115IPEXT - Manual (Page 13)

9
Upon boot-up, including following a reset, SV1115IPEXT will display
a window on the local video output (front VGA connector), that will
appear as follows:
The initial screen will display the IP address assigned by your existing
DHCP server (if present on your network). If no DHCP server is
detected, a factory assigned IP address will be displayed in its place
(10.0.0.15 by default). Please make note of the assigned IP address,
as you will need to enter it into your web browser to access the Web
Interface.
If static IP addresses are assigned, you will likely need to change the
Net Mask, IP Address and other details, prior to connecting via your
Web browser. If this is the case, connect a local keyboard (USB or
PS/2) and press the Enter key. In order to proceed, you will require an
administrative username and password. By default, the username and
password are admin. You will be given the opportunity to change the
password (recommended) once the configuration is complete.
Alternatively, you may press the Setup button on the front panel, and
you will not be asked to enter the admin password if you just press
Enter.
At the main OSD menu (pictured below), you will be given several
basic setup options. To configure SV1115IPEXT to your required
network settings, use the Network Setup Wizard. To select from the
menus provided, use the arrow keys on your keyboard. At any time,
you can return to the previous menu by pressing the Page Up key.