StarTech.com SV1115IPEXT - Manual (Page 56)

52
Serial Remote Control operation
Background
The SV1115IPEXT offers a unique way to expand the functionality of
the base product. Using the integrated R-Port on the rear panel, you
can manage up to 8 serial devices using a specialized daisy-chain
technology. The SV1115IPEXT includes integrated control functionality
that allows you to monitor and configure serial devices using the
interactive Web interface. To minimize space and infrastructure
requirements, the R-Port modules use a single cable to carry both
power and the data signal. All configuration settings are stored
separately in each attached device in non-volatile memory so that they
will not be lost in the event of a power outage or disconnection.
Connecting Serial Remote Control Modules to the SV1115IPEXT
The cable for each serial device is similar to a phone cable and uses
an RJ-14 connector. For the first module, connect the cable (provided)
to the R-Port on the rear panel of the SV1115IPEXT. Connect the
opposite end to the DATA OUT (or similar) port on the Serial Remote
Control unit. Note that some devices may use an integrated cable, so
you will not need to make a separate connection on the serial device.
Once you have added the first serial device to the SV1115IPEXT, you
can connect additional modules to the DATA IN (or similar) port on the
previous module in the chain. Once the cabling is attached, the module
becomes active after a 15 second initialization period. For specific
information regarding cabling and status indicators for a specific serial
console, refer to the instructions that came with the product.
Configuring/Viewing Serial Remote Control Modules through the
Web Interface
Once you have one or more R-Port serial devices connected, you
will able to configure and manage them through the Web interface.
You may need to modify the default settings on SV1115IPEXT to
match your various R-Port modules’ default configuration. Consult
the documentation that came with your R-Port module to determine if
you need to modify the default settings to complete the installation. To
be able to configure your R-Port modules, you must be logged in as