Sony PCS-TL33 - Manual (Page 17)

17
Turning the System On/Off
Chapt
er 1 In
s
tall
a
tion and
P
rep
ar
at
ion
Turning the System On/
Off
This section describes how to turn the Video
Communication System on and off.
Before turning the system on, make sure that system
connections have been completed correctly.
For information on connecting the system, see the section
“System Connections” on page 15.
Opening the Lens Cover
The system is equipped with a lens cover to hide the
camera. Before starting a videoconference, open the lens
cover by sliding the lever for lens cover on the top of the
system to the right. If the lens cover is closed, the picture
on the local site will not be seen on the remote site.
Turning the System On
Press the (Power) switch on the PCS-TL33.
The indicator of the switch lights up in orange and power
to the Video Communication System comes on. When
powering on is complete, the indicator lights up in green.
The launcher menu appears on the display and the picture
of the local camera is also shown.
Launcher menu
When the lens cover is closed, the launcher menu appears
as follows.
• The first time the power switch is pressed after the power
cord is plugged into a wall outlet, it may take as long as ten
seconds for the indicator on the switch to light up.
• When you turn on power to the Video Communication
System for the first time after installation, the setup wizard
will appear. Set up your system following the wizard.
For information on the setup procedure using the
wizard, see “Setting Up the System for the First Time —
Initial Setup Wizard” on page 19.
• When an optional device especially designed for use with
this system, such as the Data Solution Module, is connected
for the first time, the Video Communication System may
automatically upgrade the software of the connected device.
While the upgrading message is displayed, be sure not to
turn off the Video Communication System. Doing so may
cause malfunction of the system. System malfunction may
also occur when a system power-off has been caused by an
Lever for lens cover
Camera
(Power) switch
Notes
Click Icon to go into the function. IP:012.345.678.912
IP
CLOSED
Closed
Click Icon to go into the function. IP:012.345.678.912
IP