Sony PCS-TL33 - Manual (Page 79)

79
Starting an Encrypted Videoconference via LAN
C
h
ap
te
r 6
E
n
c
ry
p
ted
V
ideoc
onf
er
enc
e v
ia LA
N
Starting an Encrypted
Videoconference via LAN
You can start an encrypted videoconference by calling a
remote party in the same manner as a basic
videoconference.
During an encrypted videoconference via LAN, either the
or icon is displayed on the screen.
The icon appears when “Proprietary” is set as the
signal encryption protocol, and appears when it is set
to “Standard”.
When no icon is displayed on the screen, transmission and
reception data will not be encrypted. Be sure to confirm
that an icon is displayed before starting an encrypted
videoconference.
When the encrypted videoconference via LAN is
disabled
If the following message appears when you call a remote
party, an encrypted videoconference via LAN is not
available.
Note
Error Messages Causes
The far-end system in not
compatible with the
encryption feature. The encryption feature is not
compatible with the remote
system.
The encryption feature on a
far-end system is disabled. The encryption feature on a
remote system is turned off,
or the encryption protocol
settings on the remote
system are different from
those on the local system.
The entered password for
the encryption feature is not
correct. The password entered on the
remote system is not the
same as that on the local
system.
The conference could not
start because the encryption
feature at the near-end side
was disabled. The encryption feature on the
local system is turned off.
The conference could not
start because the encryption
feature at the far-end side
was disabled. The encryption feature on the
remote system is turned off.
The conference could not
start because the signal
encryption method at the
near-end side differed from
that of the far-end side. The encryption protocol
settings on the remote
system are different from
those on the local system.
The standard encryption
videoconference with SIP
connection is not available. You are connected to the
remote system via SIP
connection.
The remote party rejects
answering. The settings on the remote
system are different from
those on the local system.
The encryption feature on a
far-end system is enabled. The encryption feature on the
local system is turned off.
Error Messages Causes