Simer Pumps Battery Backup System A5000-04 - Manual (Page 9)

For parts or assistance, call Simer Customer Service at 1-800-468-7867 / 1-800-546-7867
Installation 9
LED Operating Code Display System Operating Condition
Charging
Battery status
Pump status
AC power
Silenced audible alarm
System Alert
Indicates 115V AC Power is connected
NOTE: All of the situations listed above indicate normal system operation; no action is required.
However, if the BBU pump is running or has run, check the primary pump and actively monitor the
charger status for battery life. Always reset the charger after the pump runs.
During normal system operation, the ‘System Alert’ LED does not light up. The “AC Power” LED
is lighted as long as the system is plugged in to an operating AC power circuit.
Indicates Pump is running (continuous LED)
Indicates Audible alarm is switched off
Indicates Battery is charging normally
Indicates Continuous LED: battery charge is above 20%,
system is maintaining charge
Indicates Slow flashing LED: battery charge is below 20%
LED is Flashing (Slow) = LED is OFF LED is ON Continuously = =
LED is Flashing (Fast)
=
Indicates Fast flashing LED: Pump has run
Indicates Fast flashing LED: Battery pre-qualification test is running
TABLE II – Operating Code Displays (LEDs Lighted Continuously or Flashing)
Control LED: Continuous Illumination Indicates Normal Operation:
AC Power AC power is present.
Pump Status The float switch has been activated. The LED remains on (flashing) after the pump
has stopped. Depress the‘System Test’ button to reset it.
Silenced Audible Alarm Audible Alarm has been silenced. Press and release the ‘Silence Alarm’ button to
reset (activate) the audible alarm and turn OFF the LED.
Charging Indicates that the battery is charging – see Table II, above.
Battery Status A. Continuous ‘ON” - the battery voltage is above 10.9 Volts DC and capacity is
above 20%.
B. Slow Beep/Slow LED Flash - the battery’s capacity is below 20%, and voltage
is between 8.2VDC and 10.9VDC.
C. Fast Beep/Fast LED Flash - the battery has been discharged to less than
8.2VDC.
System Alert Flashing (in unison with the buzzer) indicates that the charger has entered ‘Failure
Mode’. Press the ‘System Test’ and ‘Silence Alarm’ buttons to reset it.
NOTE: If the source of the failure is not corrected, the charger will reenter ‘Failure
Mode’. See Table IV for error code information.
TABLE III – LED Function Displays (LEDs Lighted Continuously)