Symbol Technologies MC3000 - Manual (Page 164)

MC3000 Integrator Guide 8-6
Misc(2) Tab
This tab is used to configure various miscellaneous features.
Misc(3) Tab
This tab is used to configure various miscellaneous features.
WNMS This checkbox specifies whether the AirBEAM Smart Client uploads a WNMS information file at the end of each version synchronization.
Table 8-5. Misc (2) Tab
Field Description
Auto-retry This field is used to specify whether the AirBEAM Smart Client automatically retries if there is a failure during the synchronization process.
If this feature is enabled, the AirBEAM Smart Client displays a popup dialog indicating the attempt of a retry. The popup dialog is displayed
for the number of seconds specified in the Retry Delay field.
The valid values for this field are:
-1: the AirBEAM Smart Client automatically retries indefinitely.
0: the AirBEAM Smart Client does not automatically retry.
-0: the AirBEAM Smart Client automatically retries up to the number of times specified.
Retry Delay This field specifies the amount of time, in seconds, that the AirBEAM Smart Client will delay before automatically retrying after a
synchronization failure.
In-use Test This checkbox specifies whether the AirBEAM Smart Client tests to determine if a file is in-use before downloading. If the In-use Test
feature is enabled, the AirBEAM Smart Client downloads a temporary copy of any files that are in-use. If any temporary in-use files are
downloaded the AirBEAM Smart Client automatically resets the client to complete the copy of the in-use files. If the In-use Test feature is
disabled, the synchronization process fails (-813) if any download files are in-use.
Wait Welcome This checkbox specifies whether the AirBEAM Smart Client waits for the WELCOME windows to be completed before automatically
launching the synchronization process after a reset.
Close Apps This checkbox specifies whether the AirBEAM Smart Client automatically attempts to close non-system applications prior to resetting the
mobile unit. If enabled the AirBEAM Smart Client sends a WM_CLOSE message to all non-system applications before resetting the mobile
unit. This feature offers applications the opportunity to prepare (i.e. close open files) for the pending reset.
Table 8-6. Misc (3) Tab
Field Description
Use DHCP server This checkbox control specifies whether the AirBEAM Smart Client uses the DHCP response option 66 to specify the IP address of the FTP/
TFTP server.
If enabled, special RF network registry settings are required to force the DHCP server to return the "TFTP server name" field (option 66). The
special RF network registry settings are included, but commented out, in the radio network registry initialization files (essid_xxxx_yy.reg).
Table 8-4. Misc (1) Tab (Continued)
Field Description