Symbol Technologies MC3000 - Manual (Page 57)

Accessories 2-17
Cables
This section describes how to setup and use the cables. The cables are available with a variety of connection capabilities.
The following MC3000 Communication/Charge cables are available:
• Serial (RS232) Charge cable (9-pin D female with power input receptacle)
• USB Client Charge cable (standard-A connector and a barrel receptacle for power).
Use only a Symbol approved power supply output rated 5.4 VDC and minimum 3 A. Use of an alternative power
supply will void the product warranty and may cause product damage. See the MC3000 User Guide for the
power supply regulatory compliance statement.
The following printer cables are available directly from the printer manufacturer:
• O’Neil printer cable
• Zebra printer cable.
• Monarch printer cable.
Figure 2-15. Cables (MC3000 Connector)
The MC3000 Communication/Charge cables:
• Provide the mobile computer with operating and charging power when used with the Symbol approved power supply.
• Synchronize information between the mobile computer and a host computer. With customized or third party software, it can
also synchronize the mobile computer with corporate databases.
• Provide serial connection through the serial pass-through port for communication with a serial device, such as a host
computer. For communication setup procedures, see
Serial Communication Setup on page 2-30 .
• Provide USB connection through the USB pass-through port for communication with a USB device, such as a host computer.
For communication setup procedures, see
USB Connection Setup on page 2-32 .
Dedicated printer cables, provide communication with a dedicated printer.