Summit BROTHER HL-630 OPC - Manual (Page 35)

35
actuator (or flag) is next to the small gear). On some
cartridges the "flag gear" is now black. It is located
to the bottom right of the white gear. Make sure that
when you snap the green end cap back on, the notch
on the small gear lines up with the tab on the large
single gear that is on the cartridge. Once everything
lines up, snap the end cap in place. This is tricky,
take your time!
To reset the starter cartridge, or any cartridge
through the menu, do the following:
Enter the diagnostics menu by turning the machine
on, and within 4 seconds, press "CLEAR",
"EXPOSURE MODE", "CLEAR", "EXPOSURE
MODE". (EXPOSURE MODE is the button on the
far left). All of the display will go blank. Using the
10 and 1 buttons (copy quantity), enter "24" press
"PRINT", enter "7" press "PRINT" again. The
counter is now set to Zero!
Sharp AR-150 OPC
Sharp Cartridge Part # AR-150DR
OEM Stated Yield: 18,000
To reset the cartridge through the menu, do the
following:
Enter the diagnostics menu by turning the machine
on, and within 4 seconds, press "CLEAR",
"EXPOSURE MODE", "CLEAR", "EXPOSURE
MODE". (EXPOSURE MODE is the button on the
far left). All of the display will go blank. Using the
10 and 1 buttons (copy quantity), enter "24" press
"PRINT", enter "7" press "PRINT" again. The
counter is now set to Zero!
Sharp AL-1641/55/61 OPC
Sharp Cartridge Part # Al-100DR
OEM Stated Yield: 18,000
These machines use the AL-110TD toner cartridge
and have a different reset procedure then the normal
AL-100DR machines use.
To reset the cartridge through the menu, do the
following:
Enter the diagnostics menu by turning the machine
on, and within 4 seconds, press “#” “ *” “
CLEAR”
“*” All of the display will go blank. Using the 10
and 1 buttons (copy quantity), enter "24" press
"PRINT", enter "7" press "PRINT" again. The
counter is now set to Zero!
Xerox WorkCentre Pro 16 Series OPC
Xerox Part # 13R563
OEM Stated Yield: 18,000
The actual procedure for these machines is not
currently known. It is highly probable that the same
procedures used in the Sharp AL-1000/Xerox XD-
100 will work but this is still being investigated.
Look for updates on these machines on our web site
www.summitechnologies.com
Xerox WorkCentre Pro 215 OPC
Xerox Part # 13R563
OEM Stated Yield: 18,000
The actual procedure for these machines is not
currently known. It is highly probable that the same
procedures used in the Sharp AL-1000/Xerox XD-
100 will work but this is still being investigated.
Look for updates on these machines on our web site
www.summitechnologies.com
.
Sharp AR-152 Toner Cartridges
Sharp Cartridge Part # AR-152NT
OEM Stated Yield: 6,500
These cartridges have a “Single Use Killer Chip”.
This chip shuts down the cartridge after the first
cycle so it will be necessary to replace it each time.
Replacement chips for these cartridges are now
available. The chip is installed in the back of the
connector on the cartridge.