Summit BROTHER HL-630 OPC - Manual (Page 6)

6
for 5% pages, so it is very possible that you have an
empty cartridge with a green wheel showing, or a
half full cartridge with a red wheel showing. It all
depends on how much toner is used per page.
To reset the counter, grasp the color wheel in your
right hand, the gear assembly in your left. While
bending the wheel down, turn the wheel away from
you until it stops. You will hear a slight grinding.
That is fine as long as the wheel turns fairly easily. If
the wheel is hard to turn, you are not bending the
wheel down far enough and may damage the gears.
This can also be done by removing the cover,
removing the gear next to the wheel, and resetting
the wheel gear
Canon PC-850
Canon Cartridge
Part # F100 (F41-9921)
OEM Stated Yield: 10,000
If the "Replace Cartridge" light is still lit in the
display after replacing the cartridge, the customer
can follow the steps below to reset the copier. This
procedure should be done every time the cartridge is
replaced:
Hold down the "A" (Automatic Exposure) key for
approximately four (4) seconds or longer.
After approximately four (4) seconds have elapsed,
"UC" appears in the Copy quantity/Copy ratio
display. Press the "Start" key. "UC" will flash for
about 20 seconds in the Copy quantity/Copy ratio
display. The copier will automatically perform a
toner distribution operation, and then you will return
to the normal copying mode.
NOTE: - Be sure to press the "A" key after
replacing each cartridge. If you do not, your first
few copies will not be clear copy images or the
Replace Cartridge indicator may light. If either of
these two problems occurs, press the main unit
power switch to OFF and then to ON again.
Afterwards, perform the above steps.
If copies are too dark or too light after you have
replaced the cartridge, open the front door and adjust
the copy exposure using the exposure re-calibration
slide control switch.
DEX 625 (Samsung SF-5500)
Dex Cartridge
Part # 6950
OEM Stated Yield: 12,000
This cartridge is actually two separate cartridges, a
toner and a drum cartridge. They are sold as one unit
under part # 6950.
NOTE: It is very easy to ruin the sensor on these
cartridges when cleaning. They are very static
sensitive. We highly recommend that the sensor be
removed before cleaning and replaced before the
cartridge is filled. (There is a hole in the chamber
that will leak if not replaced.
There are two reset procedures that must be followed
in order to have this cartridge operate properly. On
the drum unit there is a glass fuse that must be
replaced. The fuse is a 125V,100mA, 5x20mm fast
acting glass type. Once the cartridge(s) have been
installed, you must perform the toner initialization.
Press FUNCTION, 7, YES, NO, YES, YES. The
machine is reset!
Fuji-Xerox XP-11 Toner & OPC
(Xerox 4030)
Xerox Part #’s 6R281/13R32
OEM Stated Yield: 20,000
With the printer off, press and hold the reset button
located next to the power cord. While still holding
the reset button in, turn the power on. The reset
procedure is the same for both the toner and drum
cartridges.