Summit BROTHER HL-630 OPC - Manual (Page 36)

36
Sharp AR-152 Developer
Sharp Cartridge Part # AR-152DV
OEM Stated Yield: 25,000
The developer is rated for 25,000 pages. The default
setting on the machine is to keep running even after
the 25K pages. That default setting can be set by the
dealer to stop at 25K pages. It is considered a dealer
option.
To clear the developer after a stop, or to reset the
counter, simulation 24-06 must be run.
To enter the simulation mode, press the “CLEAR
KEY”, EXPOSURE SELECT KEY”, “CLEAR
KEY”, EXPOSURE SELECT KEY”.
Press 24
Press 06
Press “PRINT” The developer count is now cleared.
Sharp AR-152 OPC
Sharp Cartridge Part # AR-152DR
OEM Stated Yield: 25,000
Inside the drum cover, there is a gear with a “Flag”
on it. Remove the gear and place it so the flag is at
the 12:00 position. This flag when the cartridge is
installed, will turn down, and engage a switch in the
machine. This tells the machine there is a new drum.
If the drum unit has never been rebuilt, this flag gear
is not there. It can be ordered from Sharp, but there
is also a reset that can be done through the menu.
To clear the drum count if the flag gear is not
present, simulation 24-07 must be run.
To enter the simulation mode, press the “CLEAR
KEY”, EXPOSURE SELECT KEY”, “CLEAR
KEY”, EXPOSURE SELECT KEY”.
Press 24
Press 07
Press “PRINT” The drum count is now cleared.
Sharp AR-160 OPC
Sharp Cartridge Part # AR-200DR
OEM Stated Yield:
Inside the drum cover, there are two white gears.
The larger gear has a white tab that must be placed at
the 12:00 Position. The smaller gear has two small
tabs that must also be place at 12:00.
Sharp AR-163
TONER
Sharp Cartridge Part # AR-201NT
OEM Stated Yield: 13,000
These cartridges have a “Single Use Killer Chip”.
This chip shuts down the cartridge after the first
cycle so it will be necessary to replace it each time.
Replacement chips for these cartridges are now
available. The chip is installed in the back of the
connector on the cartridge.
Sharp AR-163 Developer