Sanyo PJ MASTER POA-PJNM01 - Manual (Page 34)

34
Chapter 3 Basic operation
Condition setting example
1. Select a target on the status list view window or a server on the tree view window.
2. Click
or button on the tool bar or select Global Setting from Projector or PDP menu.
The setting window will appear.
- The commands which are not effective to the selection are disabled.
3. Click Condition to open the condition setting window.
4. Click Add to open another setting window. Enter command and status, and set retry on or off.
Item Setting example
Command: CR MODELNM
Status: PLC-XP50
Retry: OFF -- only execute command once.
* The above condition is to check if the model name of the targets is “PLC-XP50”.
5. Click OK to register a new condition command. The new command list appears in the command
condition window.
6. Repeat 4 to 5 steps for another commands.
Item Setting example
Command: CR0
Status: 00
Retry: ON -- execute command “CR0” repeatedly until the status is “00”.
* The above condition is to check if the power status of the targets is “Power-On”.
7. Tick check box next to the command names you want to use for condition check.
8. Click
OK to set the condition command.