Sharp AR-350 - Manual (Page 85)

5-17
5
SADDLE STITCH FINISHER
If the saddle stitch finisher is installed, the offset function that stacks each set offset and the saddle stitch function that
staples automatically at the center of paper and folds paper in two can be used. Also punching can be performed on
printed paper if a punch unit is installed as a peripheral unit.
Part names
NOTES
● Do not put pressure on the saddle stitch finisher (particularly each tray).
● Be careful about the offset tray during printing because the tray moves up and down.
● Some other peripheral units may be needed for installation of the saddle stitch finisher and some peripheral units cannot
be installed together with the saddle stitch finisher. For combination of the peripheral units, see the list of combination of
peripheral units on page xxxx.
Offset tray
The offset function and the
stapling function can be used only
in this tray. Facsimile output is
delivered to this tray.
Saddle stitch book tray
Paper on which saddle stitch has
been made is output here.
Top cover
Open for misfeed removal.
Front cover
Open to replace the staple cartridge
or to remove jammed staples.
Stapler section
Open the front cover and pull
out this section to replace the
staple cartridge or to remove
jammed staples.
Specifications
Name Saddle stitch finisher
Number of trays 2
Exit system Print face down
Tray type Upper tray: offset tray, Lower tray: saddle stitch book tray
Paper capacity Upper tray: 1,000 sheets (8-1/2" x 11" or A4 size, 20 lbs. or 80 g/m 2 ) or 500
sheets (8-1/2" x 14" or B4 size or larger, 20 lbs. or 80 g/m 2 ), Lower tray:
Paper size Upper tray: max. 11" x 17" or A3, min. 5-1/2" x 8-1/2"R or A5R
Lower tray: max. 11" x 17" or A3, min. 8-1/2" x 11"R or A4R
Paper weight Upper tray: 15 to 54 lbs. or 56 to 205 g/m 2
Lower tray: 17 to 34 lbs. or 64 to 128 g/m 2
Paper type Upper tray:same as the specifications of paper for feeding in the main unit
Lower tray:
Paper limit detection Provided in the upper tray only
Offset function Provided in the upper tray only, offset amount: xx inch (xx mm)
Paper size for stapling Upper tray:11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, A3,
B4, A4, A4R, B5, and B5R
Lower tray: 11" x 17", 8-1/2" x 11"R, A3, B4, and A4R
Stapling capacity 8-1/2" x 11" or A4 or smaller size: 50 sheets*(20 lbs. or 80 g/m 2 )
8-1/2" x 14" or B4 or larger size: 25 sheets*(20 lbs. or 80 g/m 2 )
*Up to two sheets of 34 lbs. or 128 g/m 2 paper can be included as covers.
Stapler compiler
Paper to be stapled is stacked
temporarily.