Sharp AR-350 - Manual (Page 91)

5-23
5
SADDLE STITCH FINISHER
9 Remove the staple box.
10 Raise the lever at the end of the staple box.
If the top staple is bent, be
sure to cut it out. If bent
staples remain, a staple jam
may occur.
11 Return the lever to its original position.
12 Insert the staple box.
Push the staple box until it
clicks into place.
13 Push back the stapler section.
14 Close the front cover.
NOTE
Execute test printing in the staple sort mode to ensure
that stapling is performed properly.
■ Punch scrap disposal
1 Pull the knob and slide the saddle stitch
finisher away from the main unit.
2 Pull out the punch scrap collecting
container and remove the punch scraps.
Be careful not to scatter
punch scraps. Put them in
a plastic bag or the like for
disposal.
3 Return the punch scrap collecting
container to its original position.
4 Push the saddle stitch finisher to the main
unit.