Sharp AR-350 - Manual (Page 94)

5-26
SADDLE STITCH FINISHER
Troubleshooting (concerning the saddle stitch finisher)
Check the list below before contacting the SHARP Service Center.
Problem
Stapling position
is not correct
(including saddle
stitch).
The saddle stitch
finisher does not
operate.
Stapling cannot
be performed
(including saddle
stitch).
Punch position is
not proper.*1
Cannot be
punched.*1
Not properly
arranged if the
saddle stitch
function is used in
the copy mode.
Solution
Check the stapling position setting. (See page
xx.)
Close all covers. (See pages xx and xx.)
Remove all remaining paper from the stapler
compiler referring to step 3 on page xx.
Remove jammed staples. (See page xx.)
Replace the staple cartridge. (See page xx.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Check the punch position and set it again. (See page
xxxx.)
Dispose of punch scraps. (See page xxxx.)
Punching cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Set the pamphlet copy function and then perform
saddle stitch.
●Stapling position not set properly in the
stapling setting?
●The top cover or the front cover of the
saddle stitch finisher open?
●Message indicating need to remove
paper from the stapler compiler
displayed?
●Message requesting check for the
staple unit displayed?
●Message requesting adding staples
displayed?
●Different size paper included?
●Paper heavily curled?
●Punch function set properly in
accordance with the punch position?
●Message requesting check for punch
module displayed?
●Different size paper included?
●Paper heavily curled?
●Pamphlet copy set?
*1 When a punch unit is installed as a peripheral unit