Sharp AR-350 - Manual (Page 98)

6-2
KEY OPERATOR PROGRAMS
This chapter describes the operation method of the key operator programs concerning the printer feature and the
programs common to all features including the copier feature and the facsimile feature. These programs are provided
for use by the key operator of this product. For key operator programs specific to the copier feature, facsimile feature,
and network scanner feature, see the respective operation manuals. The key operator programs can only be accessed
after a key operator code number has been entered.
The titles displayed on the touch panel are shown with { }.
NOTE
Depending on the main unit model and installation of peripheral units, some key operator programs cannot be used.
Key operator proguram list
Program name Page
Auditor settings
Auditing mode xxxx
Print per account {Total pages per account} xxxx
Reset account {Resetting account} xxxx
Account number control xxxx
No print if account # invalid xxxx
Energy save
Auto power shut-off timer xxxx
Preheat mode xxxx
Toner save
{Toner save in printer mode} xxxx
Auto power shut-off xxxx
Operation panel settings
Auto clear setting xxxx
Message display time xxxx
Language setting xxxx
{Beep setting} xxxx
{Disabling of job priority operation} xxxx
Device settings
Disable duplex unit xxxx
Disable stapler unit xxxx
Disable paper desk drawers xxxx
Disable finisher xxxx
Disable mail-bin stacker xxxx
Saddle stitch adjust xxxx
Print key operator program list xxxx
Key operator code change xxxx
System settings
Default settings
Print density level xxxx
Disable notice page printing xxxx
Disable test page printing xxxx
A4/letter auto select xxxx
Interface settings
Hexadecimal dump mode xxxx
PDL for parallel port
{Parallel port emulation switching} xxxx
PDL for network port
{Network port emulation switching} xxxx
I/O timeout xxxx
Port switching xxxx
Network settings
IP address setting xxxx
IP subnet mask xxxx
IP gateway xxxx
Enable TCP/IP xxxx
Enable NetWare xxxx
Enable EtherTalk xxxx
Enable NetBEUI xxxx
Reset the NIC xxxx
Initialize/store settings
Restore factory defaults xxxx
Store current configuration xxxx
Restore configuration xxxx
Product key xxxx