Saturn 2009 VUE Hybrid - Manual (Page 252)

9. Now connect the black
negative (
−
) cable to the
negative (
−
) terminal of the good
battery. Use a remote negative (
−
)
terminal if the vehicle has one. Do
not let the other end touch
anything until the next step. The
other end of the negative (
− )
cable does not go to the dead
battery. It goes to your vehicle’s
remote negative (
− ) terminal. The
electrical connection is just as
good there, and the chance of
sparks getting back to the battery
is much less.
10. Try to start the hybrid vehicle.
Notice: If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct order,
making sure that the cables do not
touch each other or other metal.
A. Heavy, Unpainted Metal Engine
Part or Remote Negative ( − )
Terminal
B. Good Battery or Remote
Positive (+) and Remote
Negative (
− ) Terminals
C. Dead Battery or Remote
Positive (+) Terminal
To disconnect the jumper cables
from both vehicles, do the following:
1. Disconnect the black negative ( − )
cable from the vehicle that had
the dead battery.
2. Disconnect the black negative (
−
)
cable from the vehicle with the
good battery.
3. Disconnect the red positive (+)
cable from the vehicle with the
good battery.
4. Disconnect the red positive (+)
cable from the other vehicle.
5. Close the remote positive
junction box cover.
Jumper Cable Removal
5-32 Service and Appearance Care