Sunbeam 08EM1 User Manual
Page 6
9
10
Digital Timer Mode
The Digital Timer Mode allows you to set a time and temperature at which
The Digital Timer Mode allows you to set a time and temperature at which
your meal will cook, anytime from 30 minutes to 20 hours (in half-hour
your meal will cook, anytime from 30 minutes to 20 hours (in half-hour
increments). The digital display counts down the remaining cook time and
increments). The digital display counts down the remaining cook time and
when cooking is complete, automatically switches to the WARM setting so
when cooking is complete, automatically switches to the WARM setting so
that your meal stays
that your meal stays WARM
WARM until it is served.
until it is served.
1. Press the TEMP button until either LOW or HIGH illuminates.
• WARM is ONLY for keeping already cooked food at the perfect serving
temperature. DO NOT cook on the WARM setting.
2. Turn the SET TIME dial to select the amount of time you want to cook
at the selected temperature.
• Each rotation increases time in increments of 30 minutes. You may
also hold the dial to the right or left to rapidly increase or decrease
the time setting.
3. Press the START/STOP button to start cooking.
• The amount of time that you dialed shows in the upper display and
starts counting down and the corresponding temperature light
remains illuminated.
• When the selected time expires, the slow cooker beeps twice and
switches to the WARM setting. WARM shows in the upper display
and the WARM light illuminates.
4. To turn off the slow cooker, press the START/STOP button, then unplug
it from the outlet.
Note
Note: Temperature Probe can not be used in Digital Timer Mode.
Dual-Cycle Mode
The Dual-Cycle Mode operates the same way as the Digital Timer Mode,
The Dual-Cycle Mode operates the same way as the Digital Timer Mode,
but it takes things one step further! This mode allows you to set your
but it takes things one step further! This mode allows you to set your
slow cooker to cook at one temperature for a specified time and then
slow cooker to cook at one temperature for a specified time and then
automatically switch over to another temperature for additional time before
automatically switch over to another temperature for additional time before
switching to the WARM setting.
switching to the WARM setting.
1. Press the TEMP button until either LOW or HIGH illuminates.
• WARM is ONLY for keeping already cooked food at the perfect serving
temperature. DO NOT cook on the WARM setting.
2. Rotate the SET TIME dial to select the amount of time you want to cook
at the 1st selected temperature.
• Each rotation increases time in increments of 30 minutes. You may
also hold the dial to the right or left to rapidly increase or decrease
the time setting.
3. Press the CYCLE button.
4. Rotate the SET TIME dial to select the amount of time you want to cook
at the 2
nd
temperature.
5. Press the START/STOP button to start cooking.
• When slow cooker has run for the selected time on CYCLE 1, the slow
cooker beeps once and switches to the CYCLE 2 program for the
selected time.
• Once CYCLE 2 has run for the selected time, the slow cooker beeps
twice and switches to the WARM setting. The slow cooker remains on
WARM until you turn it off.
• To change any settings after you have already pressed the START/
STOP button, you must make your new selections and press the
START/STOP button so that the slow cooker recognizes the new
settings.
6. To turn off the slow cooker, press the START/STOP button, then unplug
it from the outlet.
Note
Note: Temperature Probe can not be used in Dual-Cycle Mode.
6 QT Smart-Set 08EM1.indd Sec1:9-Sec1:10
6 QT Smart-Set 08EM1.indd Sec1:9-Sec1:10
4/17/08 6:21:20 PM
4/17/08 6:21:20 PM