Sony SNC-VL10P - Manual (Page 23)

Se
tt
in
g
s
b
y
A
d
m
ini
s
tra
to
r
Sending Images via E-mail at Alarm — SMTP Setting Page
23
mark on Black to display the caption with black letters
on a white background.
Focus Area
Use this function when you want to focus on a portion of
the monitor image by masking over the other portion.
The focused portion is called “focus area.” With
masking, the transmitting data size reduces and a higher
frame rate is obtained.
New Area: Click to show the check mark to determine
a new focus area on the image. Drag the mouse to make
a dotted frame on the area you want to set as the focus
area and left-click. A new focus area is now set.
Enable Area: Click to show the check mark to enable
the predetermined focus area and mask over the non-
focus area.
Disable Area: Click to show the check mark to remove
the masking and resume the normal image.
Masking Level: Select the masking level from Level 1
to Level 5. A higher masking level gives a larger
masking density and higher frame rate.
Image Quality
Selects the image quality from Level 0 to Level 9. A
higher level gives a higher quality image but the frame
rate becomes lower.
Capture
When you click Capture, the monitor image freezes and
the “Saving” dialog appears. Type the file name, select
the file format, specify the destination to which the file
is to be stored, and click Save.
This function is the same as when you click the Capture
icon on the image control section. (See “Capturing the
monitor image” on page 11.)
Camera Installation Angle
Rotates the monitor image according to the camera
angle.
Select Normal, 90 deg, 180 deg, or 270 deg from the
drop-down list.
Note
The monitor image output from the VIDEO OUT
connector (composite output) cannot be rotated.
Apply/Cancel/Help
See “Buttons common to every setting page” on page
15.
Sending Images via E-
mail at Alarm
— SMTP Setting Page
When you click SMTP in the menu section, the SMTP
Setting page appears.
Use this page to set up for sending monitor images
attached to an E-mail.
Recipient Email Address
Type a recipient E-mail address in each box. You can set
two E-mail addresses.
Sender Email Address
Type the sender (camera) E-mail address in the box.
Options
Use Relay-Email-Server
When you want to send E-mails passing through a
specified server, select this check box and type the
server name in the box.
Content-Encoding-Type
Selects the format with which the image data attached to
E-mails are encoded. Select Quoted Printable or
Base64 from the drop-down list.
Email Event
Set the trigger with which you send E-mails. You can
select one or more trigger(s) from among Activity
Detection (AD), Sensor Input (SI) and Periodic Sending
(PS).