Sony SNC-VL10P - Manual (Page 25)

Se
tt
in
g
s
b
y
A
d
m
ini
s
tra
to
r
Sending Images to FTP Server at Alarm — FTP Setting Page
25
Sending Images to FTP
Server at Alarm
— FTP Setting Page
When you click FTP in the menu section, the FTP
Setting page appears.
Use this page to set up for sending monitor images to an
FTP (File Transfer Protocol) server. You can specify
two FTP servers.
FTP Server 1
Set the information of FTP server 1 in the boxes.
Address
Type the host address of FTP server 1.
User ID
Type the user ID for FTP server 1.
User Password
Type the user password for FTP server 1.
Pathname
Type the default path for FTP server 1.
FTP Server 2
Set the information of FTP server 2 in the boxes.
Address
Type the host address of FTP server 2.
User ID
Type the user ID for FTP server 2.
User Password
Type the user password for FTP server 2.
Pathname
Type the default path for FTP server 2.
FTP Event
Set the trigger with which you send images to the FTP
server(s). You can select one or more trigger(s) from
among Activity Detection (AD), Sensor Input (SI) and
Periodic Sending (PS).
Activity Detection (AD)
Select this check box to send images to the FTP server(s)
when an alarm triggered by the activity detection is
output. You can set the time and the frame rate to save
images to be sent to the FTP server(s) in the boxes
below.
Setting example: To save images during the period of
time between 2 seconds before and 2 seconds after the
alarm, with a frame rate of 3 fps.
Pre-Alarm Time: Select from the drop-down list the
time in seconds you want to save images before an alarm
output. (0 to 5 seconds can be set.)
Pre-Alarm Frame Rate: Select from the drop-down list
the frame rate with which you want to save images
before an alarm output. (1 to 5 fps can be set.)
Post-Alarm Time: Select from the drop-down list the
time in seconds you want to save images after an alarm
output. (0 to 5 seconds can be set.)
Post-Alarm Frame Rate: Select from the drop-down
list the frame rate with which you want to save images
after an alarm output. (1 to 5 fps can be set.)
Sensor Input (SI)
Select this check box to send images to the FTP server(s)
when an alarm triggered by the sensor input is output.
You can set the time and the frame rate for saving images
in the boxes below.
Pre-Alarm Time: Select from the drop-down list the
time in seconds you want to save images before an alarm
output. (0 to 5 seconds can be set.)
Pre-Alarm Frame Rate: Select from the drop-down list
the frame rate with which you want to save images
before an alarm output. (1 to 5 fps can be set.)
Post-Alarm Time: Select from the drop-down list the
time in seconds you want to save images after an alarm
output. (0 to 5 seconds can be set.)
Post-Alarm Frame Rate: Select from the drop-down
list the frame rate with which you want to save images
after an alarm output. (1 to 5 fps can be set.)