Configuring the serial port, Serial setting page – Sony SNC-VL10P User Manual
Page 26
Se
tt
in
g
s
b
y
A
d
m
ini
s
tra
to
r
Configuring the Serial Port — Serial Setting Page
26
Periodic Sending (PS)
Select this check box to send images to the FTP server(s)
periodically regardless of alarm output.
Setting example: To send images to the FTP server(s)
every hour
Interval: Type the interval at which you want to send
images to the FTP server(s) in the boxes. You can set the
hour (H) between 0 and 168, the minutes (M) between 0
and 59, and the seconds between 0 and 55 in units of 5
seconds.
Image Size
Displays the size of the image to be sent to the FTP
server(s). It is fixed to 360 × 288.
Naming Method
Set the form of naming the image file to be sent to the
FTP server(s). Select the check box(es) you want to add
to the file name.
Date & Time Suffix
Adds the date and time to the file name.
Alarm Sensor
Adds the alarm mode to the file name.
AD: if the image is sent at the time of an alarm triggered
by the activity detection.
SI: if the image is sent at the time of an alarm triggered
by the sensor input.
PS: if the image is sent by Periodic Sending.
SEQ suffix
Adds consecutive numbers, 000 to 999, to the file name.
The number is reset to 000 when you click Apply on the
FTP Setting page.
Manual Assigned Name
Type the file name up to 36 characters.
Suffix
Displays an extension “.eye.” The image is always sent
in the Wavelet compressed format and “.eye” is added to
its file name.
The example of a display
An example of the form you have set is displayed when
you click Apply.
Apply/Cancel/Help
See “Buttons common to every setting page” on page
15.
Configuring the Serial
Port
— Serial Setting Page
When you click Serial in the menu section, the Serial
Setting page appears.
Use this page to configure the RS485/232C serial port
on the rear panel of the camera.
Serial Port Selection
Select the protocol for the serial port from the drop-
down list. The selected protocol is automatically
displayed in Port Device Name.
Serial#1
Select this option when using RS-232C protocol.
Serial#2
Select this option when using RS-485 protocol.
Port Device Name
Displays the setting of Serial Port Selection.
Serial Transport
Select from the drop-down list, On to enable the RS485/
232C port, or Off to disable it.
Apply/Cancel/Help