SimpleTech ZeusIOPS - Manual (Page 25)

Zeus IOPS 3.5-Inch Fibre Channel Solid State Drive Product Manual Rev. 1.0 25
M OUNT T IME
The amount of time required to initialize and mount a Zeus IOPS SSD varies according to the operating
system (Windows®, Linux®, etc.) and the storage capacity of the drive.
A CCESS T IME
Unlike a magnetic rotating disk, the Zeus
IOPS
SSD has no moving read/write head or platter. The
access time ranges from 20 μsec to 120μsec. The actual access time may be affected by the
operating system and the storage capacity of the drive.
D ATA T RANSFER R ATES
The data transfer rates of the SSD are outlined in Table 2. Access times are measured under nominal
temperature and voltages from a representative sample of the drive. The access times are measured
from receipt of last byte of the Command Descriptor Block (CDB) to the request for a Status Byte
Transfer to the Initiator, excluding Connect/Disconnect.
Table 2. Data Transfer Rates
Parameter Value Units
Average Access 20 - 120 μsec
Average Latency 0 m/sec
Sustained Read 200 Megabytes/sec
Sustained Write 100 Megabytes/sec
Duplex Burst Read 400 Megabytes/sec
Duplex Burst Write 400 Megabytes/sec
Minimum Sector Interleave 1:1