SimpleTech ZeusIOPS - Manual (Page 28)

28 Zeus IOPS 3.5-Inch Fibre Channel Solid State Drive Product Manual Rev. 1.0
E
LECTRICAL
S
PECIFICATIONS
P OWER S UPPLY
The following voltage specification applies to the drive power connector. Connections to the drive
should be made in a safety extra low voltage (SELV) circuit.
The drive does not use the +5V supply input pins available on a typical 40-Pin SCA-2 connector.
The drive uses the +12V supply input. The 5V ground pins are connected to the common ground
plane within the unit.
Adequate secondary over-current protection must be incorporated in the host system (drive
enclosure, backplane, etc.). A 10 amp limit is required for safety purposes.
P OWER R EQUIREMENTS
The Zeus IOPS 3.5-inch Fibre Channel SSD requires a 12V +/-10% DC power source. If a power
failure occurs, the drive design ensures that the data contained in the storage memory is preserved.
Data loss or corruption does not occur.
Table 5. Zeus IOPS 3.5-Inch SSD Power Requirements
P OWER C ONSUMPTION
Table 6.
Zeus IOPS Fibre Channel SSD Typical Power Consumption
CAUTION: To avoid damage to the drive, power
supply voltage transients must not exceed 16
volts.
Item Requirement
Input Voltage 12V +/-10%
Minimum Voltage 10.8
Maximum Voltage 13.2
Activity Average Current (mA) Average Power (W)
Startup 1,200 14.4
Idle 450 5.4
Max Read @ 200MB/sec 700 8.4
Max Write @ 100MB/sec 675 8.1
Read, 1 Block Random I/O @ > 50,000 525 6.3
Write, 1 Block Random I/O @ > 18,000 660 7.9