Sagem SAGEMFAST 1500WG - Manual (Page 55)

4 - Configuring the SAGEM F@st™ 1500 ADSL router
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Reproduction and communication prohibited without the written permission of E E E E Page 4-9
Once the ADSL Router has been connected to the Internet, you get the following message:
4.2.2 Channel and SSID
Now, you can start the wireless configuration.
You must specify a common radio channel and SSID (Service Set ID) to be used by the
SAGEM F@st™ 1500
ADSL Router and all of its wireless clients. Be sure you configure all of its
clients to the same values.
Parameter Description
ESSID Extended Service Set ID. The ESSID must be the same on the SAGEM
F@st™ 1500 ADSL Router and all of its wireless clients.
ESSID Broadcast Enable or disable the broadcasting of the SSID.
Wireless Mode This device supports both 802.11g and 802.11b wireless networks. Make
your selection depending on the type of wireless network that you have.
Channel The radio channel used by the wireless router and its clients to
communicate with each other. This channel number must be the same
on the ADSL Router and all of its wireless clients.