Sun Microsystems 1.0 - Manual (Page 119)

Using the SunFDDI Network Utilities 93
8
RecvP (Receive Packets)
Running pf_stat without an interval and count displays the total number of
packets received since the interface was activated. Running pf_stat with an
interval and count displays the number of packets received since the last
interrogation.
Example Local Statistics
The following output was recovered from a single-attached station using the
command shown. A temporary fault condition was simulated by disconnecting
the FDDI cable from the SunFDDI/P card and then reconnecting it.
Note the following observations regarding this example:
•
Accumulated statistics are displayed automatically after every tenth
interrogation.
• The combination of Ring=DOWN and RMT=ISOLATED indicate that the
station is disconnected from the network.
Start pf_stat ---------->
Accumulated statistics ->
Path disconnected ------>
Path re-established ---->
(Ring_OP received )
Accumulated statistics ->
Finish pf_stat --------->
# <basedir> /pf_stat pf0 1 20
Ring ECM RMT PCMS Ring_OP XmitP RecvP
UP IN RING_OP ACTIVE 2 26 1d
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
DOWN IN ISOLATED CONNECT 0 1 1
DOWN IN ISOLATED CONNECT 0 0 0
DOWN IN ISOLATED NEXT 0 0 0
UP IN RING_OP ACTIVE 1 0 0
UP IN RING_OP ACTIVE 0 1 1
Ring ECM RMT PCMS Ring_OP XmitP RecvP
UP IN RING_OP ACTIVE 3 29 20
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 1 1
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 0 0
UP IN RING_OP ACTIVE 0 1 1