Sanyo SANUPS E11A102A - Manual (Page 45)

− 42 −
LED blinking for setting up menu
For the following two Menu Item,
• “Restart time (battery charge rate)” in the E11A Instruction Manual §10.1 “Setup
Menu Item List No.⑦”.
• “Low battery voltage signal timing” in the E11A Instruction Manual §10.1 “Setup
Menu Item List No.⑫”.
when confirming two items using control panel of UPS, the positions of the LED blinking for
setting up menu might be different from description in the E11A Instruction Manual.
Refer to §10.2 “Setup Menu Operations” in the Instruction Manual of E11A to confirm the
Menu Item.
These might be blinking as follows.
“Restart time (battery charge rate)” setting “Low battery voltage signal timing” setting
When using “SANUPS SOFTWARE STANDALONE”, menu item setting of “SANUPS
SOFTWARE STANDALONE” has priority over UPS setting. Therefore above condition might
occur.
When setting change is required, configure the menu item using “SANUPS SOFTWARE
STANDALONE”.
●： LED blinks
○： LED off