Samsung CLP-600 - Manual (Page 48)

Solving Problems
7.6
C AUTION :
• Do not touch the green surface, the OPC drum, on the front
of each toner cartridge with your hands or any other
material. Use the handle on each cartridge in order to avoid
touching this area.
• Be careful not to scratch the surface of the paper transfer
belt.
• If you leave the access door open for more than a few
minutes, the OPC drum can be exposed to light. This will
cause damage to the OPC drum. Close the access door
should the installation need to be halted for any reason.
3
Close the access door firmly. The printer will resume
printing.
C AUTION : If the access door is not completely closed, the
printer will not operate.
Inside the Printer
If paper is jammed inside the printer, a lamp turns on at the
corresponding location on the Status map. If you use the CLP-
600N, “Jam Inside Printer” also appears on the display.
1
Using the handle, completely open the access door.
2
Open the top cover.
3
Push the levers up.
4
Open the inner cover using the handle on it and carefully
take the jammed paper out of the printer.
5 Close the inner cover and push the levers down.
C AUTION :
• Do not touch the fuser inside the inner cover. It is hot and
could cause burns! The fuser’s operating temperature is
180°C (356°F). Take care when removing paper from the
printer.
• Do not touch the green surface, the OPC drum, on the front
of each toner cartridge with your hands or any other
material. Use the handle on each cartridge in order to avoid
touching this area.
• Be careful not to scratch the surface of the paper transfer
belt.
• If you leave the access door open for more than a few
minutes, the OPC drum can be exposed to light. This will
cause damage to the OPC drum. Close the access door
should the installation need to be halted for any reason.
The fuser
is hot!