Standard Horizon QUEST+ GX1256S - Manual (Page 27)

GX1256S Page 27
(Latitude) (Longitude)
(No GPS Signal)
6. The channel number will blink during reception.
7. To stop scanning, press the [SCAN(MEM)], [16/9], [WX], or PTT key.
6.16 PRIORITY SCANNING (P-SCAN)
1. The priority channel is set to channel 16.
2. For priority scanning during M-SCAN, press and hold
the [SCAN(MEM)] key, until P-SCAN appears in the LCD.
Scanning will proceed between the memorized chan-
nels and the priority channel. The priority channel will
be scanned after each programmed channel.
: When DSC Scanning method is enabled. Default is DSC scan is ON.
3. The scanning will be performed while receiving the MEM
CH (memorized channel).
4. To stop scanning, press the [SCAN(MEM)], [16/9], [WX],
or PTT key.
NOTE
Triple watch (T/W) means the radio is watching CH70 for DSC Calls.
Dual watch (D/W) means the radio is not watching CH70 for DSC Calls.
6.17 POSITION INDICATION
The transceiver has the ability to display the vessel’s position (LAT/LON) for
Confirmation of the data, if connected to a GPS receiver.
1. Press and hold the [H/L(POS)] key, dis-
plays “LAT” and “LON” information al-
ternately every two seconds.
If the GPS receiver receives no signal,
the display will be as shown in the illus-
tration.
2. To hide the position information, press and hold the
[H/L(POS)] key again.
MEM CH. CH. 16 CH. 70 MEM CH. CH. 16 CH. 70