Standard Horizon QUEST+ GX1256S - Manual (Page 41)

GX1256S Page 41
ber) number entry.
10. Press the [UP] or [DOWN] key to scroll through num-
bers, 0-9.
11. To enter the desired number and move one space to
the right press the [CALL/SET(MENU)] key. Repeat pro-
cedure until all nine spaces of MMSI number are en-
tered.
12. If a mistake was made entering in the name or the MMSI
number repeat pressing the [CALL/SET(MENU)] key
until the wrong character is selected, then press the [UP]
or [DOWN] key to correct the entry.
13. To store the data entered, press and hold the [CALL/
SET(MENU)] key.
14. To enter another individual address, repeat steps 4 through 13.
15. To exit this menu and return to radio operation mode press the [16/9]
key.
7.8.1.2 Transmitting a Group Call
1. Select the desired channel to use Group Call for voice
communications.
2. Press the [CALL/SET(MENU)] key.
3. Press the [DOWN] key to select “GROUP.” (To cancel,
select “EXIT” with the [UP] or [DOWN] key or press [16/
9] key.)
4. Press the [CALL/SET(MENU)] key to enable setting this
item.
5. Press the [UP] or [DOWN] key to select the “Group” you
want to contact.
6. Press the [CALL/SET(MENU)] key to transmit the Group
Call signal.
7. When the Group Call signal is sent, the LCD will be as
shown in the illustration at the right.
8. After the GROUP CALL is transmitted, all the radios in
the group will switch to the designated channel.
9. Listen to the channel to make sure it is not busy, then
key the microphone and call the other vessels you de-
sire to communicate with.