Samson EXL250 - Manual (Page 21)

Optional Accessories RB2030 RECHARGEABLE BATTERY
2 Using a phillips screwdriver, remove the two screws and the Battery Connector Cover Plate.
Note: retain the cover plate and screws for future use. Remove the two M4 x 10 lower rear panel screws (to be
re-used in step 6) and pole mount thumb screw (figure 1).
3 Align the battery as in figure 2 and set its legs in the bottom of the XPL200 or XPL300 as in figure 3.
4 Connect the Battery supply cable as in figure 3. IMPORTANT! Both the connectors on the supply cable (from
the battery) and connector plug (on the cabinet) are keyed. Be sure to connect the cable correctly or you’ll
risk shorting the battery which may result in fire and/or internal amplifier failure.
5 Lift the battery into place and screw the two M4 x 14 screws into the two outer holes and the two M6 x 12
screws in the inner holes on the battery lip. Use the two M4 x 10 screws (from step 2) to secure the bottom of
the battery to the cabinet.
Charging the Battery
Before using the RB2030, the Battery must be fully charged. After following the instructions for installation, con-
nect the XPL200 or XPL300 to an outlet and turn the unit on. The battery will take 8 hours to fully charge initial-
ly. Subsequent full charges can be achieved in 4 hours. The battery level meter on the rear panel of your XPL200
or XPL300 will show a level only when the AC cord is disconnected.
IMPORTANT: The RB2030 Battery must be fully charged after each use.
figure 3 figure 4
ENGLISH
17