Sennheiser CONFERENCE SYSTEM SDC 8000 - Manual (Page 85)

Configuring the SDC 8000 system
85
Modifying the currently active interpreter configuration
You can modify the following features of the currently active interpreter
configuration:
y the main target language (A-channel)
y the second target language (B-channel)
y the auto-relay interpretation for the interpreters (auto-floor)
To modify the currently active interpreter configuration:
1. From the central unit’s operating menu, choose “ Conference ”,
“ Configuration ” and ” Current ” one after the other.
The “ Select Booth ” menu appears.
2. (Carry out this step once for each booth.)
Choose the booth number and modify:
y the main target language as described under “Configuring the main
target language (A-channel) of a booth” on page 88.
y – if necessary – the second target language as described under
“Configuring the second target language (B-channel) of a booth” on
page 88.
y – if necessary – the auto-relay interpretation for the interpreters as
described under “Enabling the auto-relay interpretation function
(Auto-floor)” on page 89.
3. After you have configured the last booth, press the EXIT key repeatedly
until the “
Save Config. ” menu appears.
4. Choose “ as Config 1 ” or “ as Config 2 ” and press the ENTER key.
The modified interpreter conifguration is saved and becomes effective
immediately.
Attention!
If you exit the “ Save Config. ” menu by pressing the EXIT key, the
interpreter configuration will not be saved! The interpreter
configuration remains unchanged!
Loading a previously saved interpreter configuration
To load a previously saved interpreter configuration:
̈
From the central unit’s operating menu, choose “ Conference ”,
“ Configuration ” and ” Load ” one after the other.
The “ Load ” menu appears.
̈
Choose “ Configuration 1 ” or “ Configuration 2 ” and press the
ENTER key.
The interpreter configuration is loaded. Since the options and the
initialization of the interpreter consoles on the central unit have
already been saved in this interpreter configuration, your
interpretation system is immediately operational. It is therefore not
necessary to initialize the interpreter consoles again.
Configuration
Current
Select Booth
Booth = 01
Save Config.
as Config 1
Press ENTER to Save
Configuration
3 Load