Sennheiser CONFERENCE SYSTEM SDC 8000 - Manual (Page 93)

Configuring the SDC 8000 system
93
̈
If all booth and desk numbers are assigned correctly, press the ENTER
key on the central unit to save this configuration.
The displays of the interpreter consoles show the languages assigned
to the A-channel and the B-channel and other related information (see
example illustration on the left).
The interpreter consoles are now ready for operation.
Loading the factory-preset default configuration for the interpretation
system
If necessary, you can load the factory-preset default configuration for the
interpretation system.
Attention!
Loading the factory-preset default configuration will delete all setting
of your current configuration! Your interpretation system then has to
be re-configured to become operational!
To load the factory-preset default configuration for the interpretation
system:
̈ From the central unit’s operating menu, choose “ Interpretation ”,
“ Initialize Units ” and “ Load Default s” one after the other.
The text “ Configuration will be overwritten. Continue? ” is
shown on the display.
̈
Press the ENTER key to replace your current configuration by the
factory-preset default configuration.
Resetting the interpretation system
You should reset the interpretation system each time you have made
changes to the configuration of the interpretation system via the central
unit. Resetting the interpretation system has no effect on the conference
system, i.e. you can make changes to the configuration of your
interpreation system even during a conference.
To reset the interpretation system:
̈
From the central unit’s operating menu, choose “ Interpretation ”
and “ Reset ” one after the other.
̈
Press the ENTER key.
The interpretation system is reset and the saved configuration
becomes effective.
01 ENG
02 ARA
00 00 00 00
FLO FLO FLO FLO
Interpretation
2 Initialize Units
Initialize Units
1 Load Defaults
Interpretation
3 Reset
Reset
Press ENTER to
perform Reset