Sharp AL-2030 - Manual (Page 57)

55
6
3 To enter the toner save mode, press the
light (
) key. The light and dark
indicator marked "1" will light up,
indicating the toner save mode is
selected.
4 Press the exposure mode selector key. The PHOTO ( ) indicator
will stop blinking and light up steadily. The light and dark indicator
marked "3" will light up. The toner save mode is now active.
USER PROGRAMS
The user programs allow the parameters of certain functions to be set, changed, or
canceled as desired.
Setting the user programs
1 Press and hold down the light ( ) key simultaneously for
more than 5 seconds until all the alarm indicators ( , , )
blink and " " appears in the display.
2 Use the left copy quantity ( ) key to select a user program
number (For the user program numbers, see the following table.).
The selected number will blink in the left side of the display.
3 Press the start ( ) key. The entered program number will be
steadily lit and the currently selected parameter number for the
program will blink on the right side of the display.
4 Select the desired parameter using the right copy quantity ( ) key.
The entered parameter number will blink on the right of the display.
To return to the standard mode, repeat the procedure but use the dark
(
) key to select exposure level "5" in step 3.
Program
No.
Mode Parameters
1 Auto clear time
1 10 sec., 2 30 sec., *3 60 sec.,
4 90 sec., 5 120 sec., 6 OFF
2 Preheat mode
*1 30 sec., 2 60 sec., 3 5 min.,
4 30 min., 5 60 min., 6 120 min.,
7 240 min.
3
Auto power shut- off
mode
*1 ON, 2 OFF
4
Auto power shut- off
timer *1 5 min., 2 30min., 3 60 min.,
4 120 min., 5 240 min.
AL-2030_2040CS.book 55 ページ ２００７年４月６日 金曜日 午前１１時３２分