Sharp AL-2030 - Manual (Page 9)

7
2
Follow the installation procedure below to use the unit properly.
SETUP PROCEDURE
When using the unit for the first time, setup the unit following the procedure shown
below.
*1 If you are only using the unit for copying, skip this step.
*2 The scanner function is only available on the AL-2040CS.
If the unit does not function properly during setup or use, or if a function
cannot be used, see "TROUBLESHOOTING THE UNIT" (p.61).
1 Open the package, and make sure that all the accessories are
supplied with the unit. (p.8)
2 Remove the protective materials. (p.9)
8 Now, you can copy (p.46), print (p.35) or scan* 2 (p.36) your
document.
3 Install the TD cartridge. (p.10)
4 Load the paper in the paper tray (p.15) or the multi-bypass
tray . (p.17)
5 Plug the other end of the power cord into the nearest outlet. (p.12)
6 Install the software.* 1 (p.19)
7 Connect the interface cable* 1 (p.25) and turn on the unit. (p.12)
2
SETTING UP THE UNIT
AL-2030_2040CS.book 7 ページ ２００７年４月６日 金曜日 午前１１時３２分