Sharp AL-2030 - Manual (Page 65)

63
8
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
) indicator will blink, while the misfeed ( ) indicator
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF"
(p.67).
1 Open the multi-bypass tray,
and then open the side
cover.
2 Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed (
) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.64).
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.64)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.65) If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.66)
If paper is misfed here, proceed
to "D: Misfeed in the lower
paper feed area". (p.66)
AL-2030_2040CS.book 63 ページ ２００７年４月６日 金曜日 午前１１時３２分