Displaying total number of copies – Sharp AL-2030 User Manual
Page 58
56
* Factory default settings are indicated with an asterisk (*).
5
Press the start (
) key. The right-hand number in the display
will be steadily lit and the entered value will be stored.
6
Press the light (
) key to return to the normal copy mode.
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
Press and hold down the clear key for approximately 5 seconds. The
total number of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
6
SPF automatic
original discharge
time
1
5 min., *2
30 min.,
3
60 min., 4
120 min.,
5
240 min., 6
OFF
10
Resolution of AUTO
& MANUAL mode
*1
300dpi, 2
600dpi
21
Reset factory
1
YES, *2
NO
24
Prevention of OC
copies when the
SPF is up function
*1
ON, 2
OFF
25
Copy effective paper
width setting function
(Bypass tray)
*1
Large (LETTER/A4 width),
2
Small (INVOICE/B5R width)
26
Copy effective paper
width setting function
(Tray 1)
*1
Large (LETTER/A4 width),
2
Small (INVOICE/B5R width)
27
Copy effective paper
width setting function
(Tray 2)
(AL-2040CS only)
*1
Large (LETTER/A4 width),
2
Small (INVOICE/B5R width)
28
Selection of copy
start state (Polygon
rotation on/off)
*1
ON, 2
OFF
29
Fusing temperature
setting when the
bypass tray is used
*1
Low, 2
High
To change the setting or to set another mode, press the clear
key. The unit will return to step 2.
Program
No.
Mode
Parameters
AL-2030_2040CS.book 56 ページ ２００７年４月６日 金曜日 午前１１時３２分