Southbend CG/22SC - Manual (Page 9)

EZ C
OM
C
OMBINATION
O
VEN
I
NSTALLATION
O PERATOR ’ S M ANUAL 1182851 REV 2 P AGE 9
INSTALLATION
Step 3: Installation of Optional Open Pan Storage
The following describes how to assemble the optional open pan storage. All holes are pre-drilled for the
provided screws.
1. Attach the legs to the oven as described in installation Step 2 on page 8.
2. Attach the two frame hangers (items “A” in the following drawing) using four screws for each hanger. The
flange-side of each hanger must be on the side of the hanger closest to the edge of the oven.
LEGS NOT SHOWN
Install legs first!
Side View Bottom View
A
A
A
3. Attach the pan-stop to the shelf by first inserting the tab on the bottom of the pan-stop through the slot
near the rear of the shelf, then tilting the pan-stop up to a vertical position (as shown in the following
drawing). Secure the pan-stop with a screw that passes through a hole in the shelf and into a threaded
hole on the tab of the pan-stop (do not fully tighten this screw yet). Position the shelf below the oven with
the shelf resting on the top of the caster flanges, as shown below.
Side of Shelf
Pan-Stop
Pan-Stop
Shelf
Tab
Pan-Stop Shelf