Southbend CG/22SC - Manual (Page 13)

EZ C
OM
C
OMBINATION
O
VEN
I
NSTALLATION
O PERATOR ’ S M ANUAL 1182851 REV 2 P AGE 13
INSTALLATION
Step 5: Electrical Connection
Each oven of a 120-volt unit has a six-foot power cord that fits any standard 120 VAC three-prong grounded
receptacle. Each oven can draw up to 8 amps, and should be plugged into an outlet with its own 15-amp
circuit breaker.
Each oven of a 208-volt unit has a hole for a strain-relief fitting on the rear of the oven and a terminal block
located inside the right-side compartment of the oven. Remove the right-side panel of each oven. Install a
strain-relief fitting in the hole, then thread the power supply cable through the strain-relief fitting and connect
it to the terminals of the terminal block according to the wiring diagram (see page 34). Finally, re-attach the
right-side panel to the oven.
NOTICE
The unit, when installed, must be electrically grounded and comply with local codes, or in the
absence of local codes with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electric
Code, CSA C22.2, as applicable.
! WARNING
A POSITIVE GROUND CONNECTION IS ESSENTIAL. DO NOT ALLOW ANY TAMPERING OR
ADJUSTMENT OF ANY CONTROL OR WIRING. THE UNIT IS FACTORY SET. ADJUSTING ANY
INTERNAL COMPONENT OTHER THAN THE MAIN FUSE BLOCK CAN VOID THE WARRANTY.
! WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance (120V ovens only) is equipped with a three-prong (grounding) plus for your protection
against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from the plug.
Step 6: Water Supply Connection
Connect a cold water line to the 3/8" female NPT “tee” connector located on the back of each oven (see
illustration on page 12).
To facilitate cleaning, plus allow access to the rear of the unit, flexible connections are recommended.
NOTICE: WATER SPECIFICATION
To meet warranty requirements, supply water must meet the following specification:
Pressure ...........................................30 to 60 psi (205 to 410 kPa)
Total Dissolved Solids (TDS)............60 PPM
Hardness ..........................................2 Grains or 35 PPM
pH Factor ..........................................7.0 to 7.5