SUPER MICRO Computer 6015B-Ni - Manual (Page 3)

Preface
About This Manual
This manual is written for professional system integrators and PC technicians. It
provides information for the installation and use of the SuperServer 6015B-Ni. In-
stallation and maintenance should be performed by experienced technicians only.
The SuperServer 6015B-Ni is an economical, dual processor server based on the
SC812L-520U 1U rackmount server chassis and the X7DBU, a dual processor
serverboard that supports Intel ® Xeon ® 5300/5100/5000 series processors at a
Front Side (System) Bus speed of 1333/1066/667 MHz and up to 32 GB of ECC
FBD DDR2-667/533 SDRAM.
Manual Organization
Chapter 1: Introduction
The fi rst chapter provides a checklist of the main components included with the
server system and describes the main features of the SUPER X7DBU serverboard
and the SC812L-520U chassis, which make up the SuperServer 6015B-Ni.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer 6015B-Ni into
a rack and check out the server confi guration prior to powering up the system. If
your server was ordered without processor and memory components, this chapter
will refer you to the appropriate sections of the manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
iii
Preface