SUPER MICRO Computer 6015B-Ni - Manual (Page 54)

5-20
S UPER S ERVER 6015B-Ni User's Manual
LAN Enable/Disable
Change the setting of jumper JPL1
or JPL2 to enable or disable the
onboard Ethernet (RJ45) ports LAN1
and LAN2, respectively. See the table
on the right for jumper settings. The
default setting is enabled
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application is “hung up”. Pins 1-2 will
cause WD to reset the system if an
application is hung up. Pins 2-3 will
generate a non-maskable interrupt sig-
nal for the application that is hung up.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in BIOS.
Note: When enabled, the user needs
to write their own application software
to disable the Watch Dog Timer.
LAN Enable/Disable
Jumper Settings (JPL1, JPL2)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
I 2 C Enable/Disable
II 2 C1 and II 2 C2 are used to enable or
disable I 2 C bus on the serverboard.
See the table on the right for jumper
settings. Both jumpers must be set
the same for the setting to to function
correctly (one jumper enables the
clock and the other enables the data).
The default setting is disabled.
I 2 C Bus Enable/Disable
Jumper Settings (II 2 C1, II 2 C2)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled