SUPER MICRO Computer 6015B-Ni - Manual (Page 60)

6-2
S UPER S ERVER 6015B-Ni Manual
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF2
can be found in "Chapter 5: Advanced Serverboard Installation."
Control Panel
Drive Bays (behind bezel)
Ethernet Ports USB Ports
Mouse Port Keyboard Port
COM1 Port
Low Profi le PCI Slot Standard PCI Slots VGA Port