Before operation – Samsung SCC-3000 User Manual
Page 12
《12》
Before Operation
(1) Power-On
① Power on the connected external devices before turning the controller on.
② Press the power button at the back of the controller to power on the controller.
③ The [SYSTEM Controller] message and F/W version will be displayed in the LCD
monitor, and the message will disappear when the controller is ready for use.
▤ The [JOYSTICK ERROR] error will be displayed in the LCD monitor if the
joystick is not placed in the center during power-on.
(2) Initial Screen Display
① CAM ID : Shows the currently selected camera ID. Default is 1.
② SPD : Shows the currently selected camera model name.
Default is SPD.
③ MONITOR : Not used; will be applied to F/W in the future.
④ [- - -] : Shows the numbers (ID) entered when entering numbers
with the number pad.
⑤ ID : Shows the current controller ID. If the ID is 1, it acts as the master
controller. If the ID is 2 or higher, it acts as a sub -controller.
Sub-controllers cannot be used independently without a master
controller.
▤ Always assign a unique ID to ensure that the controller IDs do not
conflict with each other.
▤ SPD : SPD-1600/ SPD-2200/ SPD-2500(Samsung Techwin Co., Ltd.)
PTZ CONTROL SYSTEM
CAM ID:
1
SPD
MONITOR:
1
[ --- ]
ID:
1
(3) Camera ID Setup
① Enter a number using the number pad.
② The number entered will be shown in the [- - -] display.
③ Press the CAMERA or ENTER button to set the camera ID with the
number entered.
▤ Any number from 1 to 255 can be selected. If the number entered is
not within the selectable range, the last entered number is taken as
the first number.
PTZ CONTROL SYSTEM
CAM ID:
1
SPD
MONITOR:
1
[ 5 ]
Enter:PTZ ID Set
PTZ CONTROL SYSTEM
CAM ID:
5
SPD
MONITOR:
1
[ --- ]
ID:
1
[ power button ]
①
③
②
④
⑤